D-Link Xtreme N Duo DAP-1522 Guía De Instalación Rápida página 6

1. Insert the AC/DC Power Adapter cord into the power receptacle located
on the rear panel of the DAP-1522 and plug the adapter into a suitable
nearby power source. (This unit is to be used only with the power supply
provided by the manufacturer.)
2. Check the status of the DAP-1522 by checking the LED (orange LED
blinks at bridge mode and blue LED blinks at AP mode). Push the button
on the right hand side of the DAP-1522 to initiate a secured wireless
connection.
3. Within 120 seconds, push the WPS button on the router to link them
together.
Note: To use this method, the router must be WPS ready.
4. Once the WPS button stops blinking, you can move the DAP-1522 to the
desired location.
3 3 4 4
5. Plug the Ethernet cable between the device you wish to use and the
DAP-1522, and then power on the DAP-1522.
Note: If you are using AP mode, please see the manual for more information on AP
mode setup.
D-Link DAP-1522 Quick Install Guide
Push Button Setup