Tabla de contenido
Idiomas disponibles
Idiomas disponibles
PARL-36/CR
Order No. 38.2630
LED Spotlight
GB
Please read these operating instructions carefully
prior to operation and keep them for later use.
1 Applications
This spotlight is ideally suited for private and
commercial lighting applications, e. g. as a deco-
rative light in shop windows or as an effect spot
in combination with a mirror ball. It generates
coloured light via 61 extra bright LEDs in blue,
red, and green and can be operated in three dif-
ferent modes (music-controlled change of
colour, automatic change of colour, manual
colour adjustment).
2 Safety Notes
The spotlight corresponds to all required direc-
tives of the EU and is therefore marked with
WARNING The spotlight is supplied with
hazardous mains voltage (230 V~).
Leave servicing to skilled person-
nel only. Never make any modifi-
cation on the unit and do not insert
anything into the air vents, other-
wise you will risk an electric shock!
Please observe the following items in any case:
The spotlight is suitable for indoor use only.
Protect it against dripping water and splash
water, high air humidity, and heat (admissible
ambient temperature range 0 – 40 °C).
Always place the spotlight in such a way to
ensure a sufficient air circulation during oper-
ation. Never cover the air vents on the hous-
ing. Keep a minimum distance of 10 cm to the
illuminated object.
Do not operate the spotlight or immediately dis-
connect the mains plug from the mains socket
1. in case of visible damage to the unit or to
the mains cable,
2. if a defect might have occurred after the unit
was dropped or suffered a similar accident,
3. if malfunctions occur.
In any case the unit must be repaired by
skilled personnel.
A damaged mains cable must be replaced by
the manufacturer or skilled personnel only.
Never pull the mains cable for disconnecting
the mains plug from the mains socket, always
seize the plug.
For cleaning only use a dry, soft cloth, never
use chemicals or water.
No guarantee claims for the spotlight and no
liability for any resulting damage to property
or resulting personal injuries will be accepted
if the spotlight is used for other purposes than
originally intended, if it is not safely mounted
or correctly operated, or not repaired in an
expert way.
Important for U. K. Customers!
The wires in this mains lead are coloured in
accordance with the following code:
green/yellow = earth
blue = neutral
brown = live
As the colours of the wires in the mains lead of
this appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
1. The wire which is coloured green and yel-
low must be connected to the terminal in the
plug which is marked with the letter E or by
the earth symbol
, or coloured green or
green and yellow.
®
Copyright
PARL-36/SW
Order No. 38.2640
2. The wire which is coloured blue must be
connected to the terminal which is marked
with the letter N or coloured black.
3. The wire which is coloured brown must be
connected to the terminal which is marked
with the letter L or coloured red.
Warning – This appliance must be earthed.
If the unit is to be put out of operation
definitively, take it to a local recycling
plant for a disposal which is not
harmful to the environment.
3 Mounting
The spotlight can be
a set up by unfolding the bracket (2).
b mounted with a support for lighting units
.
(C-hook) or a stable mounting screw via the
bracket to a cross arm or a stand.
c mounted on the ceiling via the supplied
mounting plate (1); screw the mounting plate
to the bracket (see fig. 1) and mount it on the
ceiling via three screws.
WARNING The spotlight must be mounted
expertly and safely. If it is installed
as a suspended load above per-
sons, it must additionally be se-
cured (e. g. by a safety rope fixed
to the bracket). Fasten the safety
rope in such a way that the maxi-
mum falling distance of the spot-
light is 20 cm.
To adjust the spotlight, slightly release the two
screws (3) on the bracket, incline the spotlight as
desired, then retighten the screws.
4 Operation
4.1 Setting the spotlight into operation
To switch on the spotlight, connect the plug of
the mains cable (8) to a socket (230 V~/50 Hz).
Whenever the spotlight is switched on, it is in the
operating mode "music-controlled change of
colour" and all adjustments made with the but-
tons (4) – (6) will be reset.
WARNING
Please note that very fast colour
changes may trigger epileptic sei-
zures with photosensitive per-
sons and persons with epilepsy!
To switch off the spotlight, disconnect the mains
plug from the socket.
For a more convenient operation, it is recom-
mended to connect the unit to a mains socket
which is switched on and off via a light switch.
4.2 Selecting the operating mode
The three operating modes of the spotlight can
be selected with the button MIC/AUTO/MANUAL
(7). Each time the button is pressed, the next
mode will be selected.
1. Music-controlled change of colour (MIC)
When music with notable rhythm in the bass
range is played at a sufficient volume, the spot-
light, controlled via an internal microphone, will
change its colour to the beat of the music.
2. Automatic change of colour (AUTO)
In this mode, the speed at which the colours
will change can be adjusted:
Each time the button
speed will be increased; each time the button
(5) is pressed, it will be reduced.
©
by MONACOR INTERNATIONAL GmbH & Co. KG, Bremen, Germany. All rights reserved.
When the button FADE (4) is pressed, the
spotlight will switch to a gradual fading be-
tween the colours. The fading speed is not
adjustable. To stop the gradual fading, press
the button FADE once again: the spotlight will
return to the change of colour at the speed
adjusted with the button
3. Manual colour adjustment (MANUAL)
In the manual mode, the LEDs for red, green,
and blue can be separately selected:
with the button G (4): activation/deactivation
of the green LEDs
with the button R (5): activation/deactivation
of the red LEDs
with the button B (6): activation/deactivation
of the blue LEDs
Press the corresponding button/s to adjust the
desired colour (red, green, blue or a mixed
colour composed of the three primary colours).
5 Specifications
Power supply: . . . . . . . 230 V~/50 Hz
Power consumption: . . 12 VA
Lamp: . . . . . . . . . . . . . . 61 extra bright LEDs
Ambient temperature: . 0 – 40 °C
Dimensions: . . . . . . . . . Ø 116 x 155 mm
Weight: . . . . . . . . . . . . 350 g
Subject to technical modification.
3
(6) is pressed, the
or
.
LED PINSPOT
G
R
B
B
R
R
B
R
G
B
G
G
B
G
B
R
G
R
R
B
G
G
R
B
R
B
G
R
R
B
G
R
B
B
G
R
B
R
B
G
G
B
B
R
G
B
R
G
R
G
G
R
G
B
R
B
B
R
R
B
G
G
4
FADE
5
6
R
B
7
MIC/AUTO/MANUAL
8
A-0553.99.01.02.2006
1
2
3
Tabla de contenido
