Atomic G01342W Manual De Instrucciones página 7

PARTS REQUIRED:
1 pc - P1 Side Apron
STEP 2:
Once your are sure you have the rods set
correctly, slide the other P1 Side Apron on
the rods as shown in FIGURE 2.
P1
R4, R5 and R6
Hole/Handle
goes on the
other end of
these rods
PARTS REQUIRED:
16 pcs - H4 Phillips Round Head Screw
2 pcs - P5 End Top Rail
2 pcs - P6 Goal End Board 4 pcs - P18 Plastic Bracket
STEP 3:
Place two P18 Plastic Brackets onto each inside
end of P6 Goal End Board as shown and attach
using the pre-drilled pilot holes with H4 Screws
as shown in FIGURE 3A.
Tighten, but do not strip out H4 screws.
NOTE: Be sure bottom edge of P18 Plastic
Brackets is flush with bottom edge of board.
Next, attach this assembly to P5 End Top Rail
using pre-drilled pilot holes with H4 Screws as
shown in FIGURE 3B.
Tighten, but do not strip out H4 screws.
NOTE: Be sure bottom edge of P6 Goal End
Board is flush with bottom edge of P5 Top Rail.
Repeat procedure for second assembly.
All Rights Reserved.
© 2012 Escalade Sports
R5
R4
R2
R6
R1, R2 and R3
Hole/Handle End
R3
R5
R1
R2
White laminate
this side
Edge must be
flush for correct
assembly
Edge must be
flush for correct
assembly
Black laminate
on bottom side
NOTE: See STEP 4 to look at
correct assembly P5 and P6.
7
C1 Rod Bushing
Note: C1 Rod Bushings
are already attached
onto P1 Side Apron
P6
P18
H4
P18
H4
H4
P6
Round Corner
this position
For Customer Service Call 1-888-996-2729
FIGURE 2
FIGURE 3A
H4
P5
FIGURE 3B