Basic Operation - Scott i-WXH125 Manual De Instrucciones

Precautions when using batteries
1. Replace only with the same or equivalent type.
2. Do not mix different types of battery together (e.g. alkaline, rechargeable and standard (carbon zinc)
or old batteries with fresh ones.
3. Exhausted batteries must be removed to prevent possible leakage.
4. Dispose of batteries properly in accordance with the environmental regulations in force.
ON/ Standby
When it is connected to a power supply (refer to "POWER SUPPLY"), the unit goes to standby mode
and the clock time is displayed. Press the
standby mode.
Setting the clock
1. In standby mode, press the TIME button and use the
format. Press the TIME button to confirm and set the clock.
2. Use the / buttons to set the hour, and press the TIME button to confirm.
3. Repeat step (2) above to set the minutes.
Selecting a source
When the unit is switched on, press the SOURCE button repeatedly on the unit or the corresponding
mode button on the remote control to select one of the following sources: "CD", "TUNER", "AUX IN",
"iPod" or "USB".
VOLUME control
Use the VOLUME +/- buttons to adjust the volume level.
MUTE
Press the MUTE button on the remote control to turn off the sound. "MUTE" will flash on the display.
Press it again or use the VOLUME +/- buttons to resume the sound.
EQ function
Press the EQ button repeatedly to select a music mode: POP (EQ1), JAZZ (EQ2), CLASSIC (EQ3),
ROCK (EQ4), FLAT.
SRS WOW
Press the button to enable or disable the SRS WOW function. When the function is enabled
"SRS WOW" is displayed.
is a trademark of SRS Labs, Inc. WOW technology is incorporated under license from SRS
Labs, Inc. WOW® significantly improves the playback quality of audio, delivering a dynamic 3D enter-
tainment experience with deep, rich bass.
Note: EQ and SRS WOW cannot be enabled together, i.e. when one function is enabled, the other will
be disabled.
Time display
When the unit is switched on, press the DISPLAY button on the remote control to display the clock
time for one second.
SIDE PANEL ILLUMINATION
Set the ILLUMINATION ON/OFF switch on the back of the unit to turn the side panel illumination on/
off.
DIMMER
Press the DIM button to adjust the brightness of the LCD backlight and the side panel illumination.

BASIC OPERATION

button to turn on the unit and press it again to go back to
GB-4
/ buttons to select 24Hr or 12Hr display