Working Modes - jbc RP 5100 Manual Del Usuario

ENGLISH
OPERATION
Use of keys
<
= Reduces values.
N (No) =Invalidates programming.
T1 = Selection of temperature 1
>
= Increases values..
Y (Yes) = Validates programming
T2 = Selection of temperature 2
Switches from one function to
another and programme enter/exit.
Start-up display
When the apparatus is turned on the message
OFF appears. The station starts up on pressing
any key.
When the message READY appears the tip of
the soldering iron will be ± 6°C from the
temperature selected.

WORKING MODES

The programme for each circuit (soldering,
desoldering) has two modes of operation which
we call LOOP 1 and LOOP 2.
LOOP 1
Quick Programming
This mode gives direct access to temperature
changes.
The temperature may be raised or lowered
degree by degree using the
and LOOP 2 may be accessed by the MODE
>
and keys.
The station is supplied from the works in LOOP 1
and the following tip types are programmed for the
R-10 D soldering iron and 20DE desoldering iron.
and changes LOOP.
< >
and
To change the tip model or the °C-°F unit the
data must be programmed in LOOP 2 and
these changes will be taken up in LOOP 1.
LOOP 2
Advanced Programming
Advanced programming system, allowing access
to the 5 functions provided by the system.
Programming
Press the MODE key as many times as
necessary to reach the function you require.
Use the key
Push the MODE key again, and the prompt
SAVE? will appear in the display.
Pressing the
while pressing the
previous data.
Functions
Tip model -TIP-
It shows the tip model selected. If you wish to
change it, use the keys
appear one by one.
Tip temperature -T1- T2-
keys
Two alternative temperatures, T1 and T2, may
be programmed within the 50°C-400°C range.
For fine soldering a low temperature is required,
which can be programmed as T1 while thick
soldering calls for a higher temperature which
can be programmed as T2.
2
< >
and to change the value shown.
>
YES key saves the new data,
<
NO key maintains the
< >
or . All the tip models