Connect The Pneumatic Power Supply; Connect The Direct Print Module; Before Initial Operation - Carl Valentin DPM IV Serie Guía De Referencia Rápida

DPM IV

Connect the Pneumatic Power Supply

The pneumatic power supply for the printhead mechanics has to be made available a minimum continuous pressure of 4 ...
6 bars in front of the pressure regulator. The maximum pressure in front of the pressure regulator is 10 bars and 4 bars after the
pressure regulator.
NOTICE!
A pneumatic power supply of 4 ... 6 bars is recommended.
Druckregler mit Manometer
Pressure regulator with manometer

Connect the Direct Print Module

The direct print module is equipped with a versatile power supply unit. The device may be operated with a mains voltage of
110 ... 230 V AC / 50 ... 60 Hz without any adjustments or modifications.
CAUTION!
The direct print module can be damaged by undefined switch-on currents.

Set the power switch to '0' before plugging in the direct print module.

Insert the plug of power cable into a grounded electrical outlet.
NOTICE!
Insufficient or missing grounding can cause faults during operation.
Ensure that all computers and connection cables connected to the direct print module are grounded.

Connect the direct print module to computer or network with a suitable cable.

Before Initial Operation


Mount the print mechanics.

Connect all cables between print mechanics and control unit.

Protect the cables against unintentional unscrewing.

Connect the compressed air line.

Connect the control unit and PC by printer interface.

Connect the control unit and the packaging machine by inputs and outputs.

Connect the power cable of control unit.
64
Druckmechanik
Print mechanics
Pneumatikschlauch
Pneumatic tube 8x1
Druckluftversorgung
Pneumatic power supply
min. 4 bar, max. 7 bar
English
Please observe the following notes:
•
The compressed-air has to be dry and oil free.
•
The supplied pressure regulator with manometer is to
connect with a plastic tube Ø 8 mm via a plugging
bolting to the pneumatic power supply. The
connection between pressure regulator and print
mechanics is established by a pneumatic tube Ø 8
mm and an appropriate push-in fitting.
•
Position pressure regulator as near as possible to the
print mechanics.
•
The pressure regulator is only to operate in the
direction of the arrow (see label at pressure
regulator). The direction shows the way of the
streaming air.
•
It is not allowed to bend the plastic tubes.
•
Shortening of the plastic tubes has to be made with a
clean right-angled cut without squashing the tube. If
necessary use special tools (available in pneumatic
requirements).
•
Keep the pneumatic tube as short as possible.