Altec Lansing M812 Guia Del Usuario página 4

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Altec Lansing M812
Introduction
Thank you for purchasing the Altec Lansing M812 Wireless Speaker
System for iPod. The M812 is a high performance speaker and
transmitter base combination that allows you to connect and
wirelessly listen to most iPods, FM radio stations and auxiliary audio
sources. Simply dock your iPod into the transmitter base or select your
favorite radio station; the signal is wirelessly transmitted from the base
to the speaker. And since there are no wires needed for the speaker,
it can be conveniently placed almost anywhere in the home. Basic
playback functions for the iPod and auxiliary audio sources can be
controlled directly from the supplied remote control.
Want audio throughout your house? Expansion is easy; you can
add up to seven optional M812 Wireless Speaker units to the
main system. Additional speaker units are available on line at
www.alteclansing.com/M812.
Please read this manual thoroughly before making connections and
plugging in the unit. Following the instructions in this manual will
enable you to obtain optimum performance and listening enjoyment
from your new M812. Please retain this manual for future reference.
Other features include:
• Wireless transmission using 2.4GHz digital radio frequency at a
range of up to 100 feet (approximately 0 meters)
• Continuous power output of 100 watts (50 watts per channel)
• FM radio with six presets
• Adjustable bass and treble controls
• Auxiliary input with IR repeater
• LCD display for easy viewing
• Full function remote
• Wall mount bracket for speaker
Precautions
1. AC Fuse
The fuse is located inside the chassis and is not user-serviceable.
If power does not come on, please contact your Altec Lansing
authorized service station.
2. Care
From time to time you should wipe the cabinet with a soft cloth.
For heavier dirt, dampen a soft cloth in a weak solution of mild
detergent and water, wring it dry, and wipe off the dirt. Following
this, dry the unit immediately with a clean cloth. Do not use rough
material, thinners, alcohol or other chemical solvents or cloths since
these could damage the finish or remove the panel lettering.
3. Power
WARNING: BEFORE PLUGGING IN THE UNIT FOR THE FIRST TIME,
READ THE FOLLOWING SECTION CAREFULLY.
The voltage of the available power supply differs according to
country or region. Be sure that the power supply voltage of the area
where this unit will be used meets the required voltage (e.g., AC120
V, 60 Hz) written on the rear panel of the speaker and transmitter
base. Setting the STANDBY key to standby does not shut off the
power completely, so the power cord should be removed from the
AC outlet when the unit is not used for a prolonged time.
FCC Information for User
CAUTION: User changes or modifications not expressly approved by
the party responsible for compliance could void the user's authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
• Select a different channel.
Box Contents
• Wireless speaker
• Transmitter base
• iPod adapters
• Remote control
• Power supply for transmitter base
• FM antenna
• IR repeater
• Wall mounting bracket
• AC power cord (for wireless speaker)
• .5 mm stereo audio cable
• User's guide and quick connect instructions
Made for:
• iPod nano
• iPod video
• iPod with color display
• iPod mini
• iPod
4
Tabla de contenido
loading

Tabla de contenido