Door/Window Sensor; Remote Control - Chacon 34949 Manual De Usuario

Ocultar thumbs

Contenido

página de 29

/ 29
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

Step 1:

To power up the Sensor, remove the Battery Tab

Step 2:

Perform a Walk Test Sensor

Press the Test Mode button at the back of the sensor to put it in Test Mode.

Place the Sensor in your desired location (don't use screws at this point), arm the

system and walk in front of the Sensor to test that the Sensor triggers the alarm.

FAQ

Failed to connect to the WiFi

the App, please make sure that your local WiFi network is available and working

properly.

Check that the WiFi name and password are correct.

Connect to a 2.4G WiFi network instead of 5G

Check that the Power Adapter is connected to the Control Panel.

Re-linking the Control Panel to the Router again by following the steps on page 7

The WiFi indicator and the status indicator are on, but I can't control the alarm by

App

Check that your smartphone is connected to a WiFi network.

Wait a few minutes to see if the WiFi indicator and the status indicator start

Panel is located in an area with good WiFi coverage and then re-pair with your local

WiFi network.

No response from the Control Panel when a Sensor is triggered

The Sensor is not within range of the Control Panel.

Check that the Sensor has been successfully paired to the Control Panel: Press any

Button on the Remote Control, arm the system and separate the Contact from the

Magnetic Sensor or press the Test Button on the Motion Sensor. You can re-pair

the Sensor to the Control Panel by following the instructions in the App – [Edit

Accessories] – [Show Me How]

Step 3:

Install the sensor

2-2.2m

r o s n e S r o s n e S

Ground

Replacing Accessory Batteries

Remote Control

Remove the screw

Open the casing

I can't Arm or Home Arm (Part Arm) my alarm by App

If the alarm has been triggered and hasn't been disarmed and a user tries to Arm or

How to delete an Accessory

You can delete any Sensor in the App by going to [Edit Accessories] and tapping

the 'bin' icon in the top right hand corner of the screen.

To delete all accessories press and hold the [Learn] button inside the Control Panel

for 3 seconds, the Control Panel will beep once to indicate that all accessories have

been deleted.

No sound when alarming

Check that the Control Panel Alarm volume is not set to mute and the ring time is

not set to '0'.

Adjust the volume and the ring time accordingly.

How to reset the alarm system

Press and hold the [WiFi] button inside the Control Panel for 7 seconds.

You will hear one short beep after 3 seconds and then a long beep after another 4

seconds.

The reset has been completed and all the settings have been restored to default

conditions.

Please note that this process does not delete any Sensors.

Delete User (submenu `More') within the App, but make sure the panel has been

connected with WiFi network before the operation.