Lubrication/Cable Installation - Ramsey PATRIOT PROFILE 12000 Manual Del Propietário

Maintenance
All moving parts in the winch are permanently lubricated
with high temperature lithium grease at the time of
assembly. Under normal conditions factory lubrication
will suffice.
Lubricate cable periodically using light penetrating oil.
Inspect the cable for broken strands and replace if nec-
essary. If the cable becomes worn or damaged, it must
be replaced.
Corrosion on electrical connections will reduce perform-
ance or may cause a short. Clean all connections espe-
cially in the remote control switch and receptacle. In salty
environments use a silicone sealer to protect from corro-
sion.
To minimize corrosion of the internal motor components
that may occur due to condensation, power the winch in
or out periodically. Energizing the motor will generate
heat, which will help dissipate any moisture buildup in
the motor. This should be performed at periodic intervals
(such as with each oil change to your vehicle). Note:
Refer to the Troubleshooting Guide if the motor has been
submerged.
Cable Installation
1. Unwind the new cable by rolling it out along the
ground to prevent kinking.
2. Remove old cable and observe the manner in which it
is attached to the cable drum flange.
3. Before installing the new cable assembly, securely
wrap the end of the cable with plastic tape or similar
tape to prevent fraying.
4. Position the cable drum so that the 1/4" diameter
threaded hole in the motor end drum flange is approx-
imately on the top.
5. Secure the cable to the drum flange using cable
anchor and capscrew shown in the parts drawing on
page 9 (Item nos. 29 and 42). Securely tighten the
capscrew, but do not over-tighten.
6. Wind 5 wraps of cable onto the drum. Wind on the
rest of the cable by pulling in a light load to keep the
tension constant. Allow the cable to swivel by using a
length of chain or a swivel block between the cable
hook and the load.
6