Main Unit Setup; Low Battery Warning; Table Stand Or Wall Mount; Main Unit - Oregon Scientific BAR888 Manual Do Usuário

Replace the batteries when the low-battery indicator
of the particular channel lights up on the main unit.
Note that once a channel is assigned to a remote unit,
you can only change it by replacing the batteries or
resetting the unit.

MAIN UNIT SETUP

To install the batteries:
1. Slide open the battery compartment door.
2. Insert the batteries according to the polarities
shown.
3. Replace the battery compartment door.
Change the batteries when the low-battery indicator
for the indoor temperature lights up.
NOTE If there is a clear plastic tab in the battery
compartment, please remove it before installing the
batteries.

LOW BATTERY WARNING

When it is time to replace batteries, the low-battery
indicator will show up when the respective channel is
selected. The battery level of the main unit will be
shown on the indoor temperature display when it is
running low.

TABLE STAND OR WALL MOUNT

The main unit has a retractable table stand, which when
flipped open, can support the unit on a flat surface. Or
you can flip close the stand and mount the unit on a
wall using the recessed screw hole.

MAIN UNIT

The main unit comes with a wall-mount holder and a
removable stand. Use either to hold the unit in place.
1. Lift up the back cover
BAR888 Eng New R0 OP
Black

REMOTE UNIT

THE RESET BUTTON

This button is only used when the unit is operating in
an unfavorable way or malfunctioning. Insert a pointed
object such as an unfolded paper clip into the reset
hole, then press and hold. All settings will return to
their default values.

GETTING STARTED

Once batteries are in place for the remote units, they
will start transmitting temperature readings at
30-second intervals.
The main unit will also start searching for signals for
about a minute once batteries are installed. Upon
successful reception, the individual channel
temperatures will be displayed on the 2nd line and the
indoors temperature on the 3rd line. The main unit will
automatically update its readings at about 30-second
intervals.
If no signals are received, blanks "
displayed and the kinetic wave icon will show "
Press CHANNEL and MEMORY simultaneously to
enforce another search for about 30 seconds. This is
useful in synchronizing the transmission and reception
of the remote and main units.
Repeat this step whenever you find discrepancies
2.Flip up the stand
between the reading shown on the main unit and the
respective remote unit.
4
4
3. Close the back cover
Wall-mount Table Stand
8/27/04, 6:39 PM
" will be
".