Tabla de contenido
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
TROUBLESHOOTING AIR SYSTEM
Inadequate Fluid Flow from the Air Brush
1. Make sure there is air going to the regulator. Unplug the "Air IN" tubing from the air pump to
make sure that air is coming out of the regulator. (This is done by sliding open the lock latch
next to the AIR IN connector on the pump and removing the hose).
2. Check to see that the regulator is adjusted properly.
3. If possible, remove the brush from the brush hose and see if there is fluid flow from the hose
without the brush attached. (If you cannot easily remove the brush from the hose, get an
empty container, slide the lock latch on the OUT connector under the air pump to unlock the
hose. Remove the brush hose and place the bucket under the opening. Turn on air and see if
fluid comes out). If fluid comes out, the brush needs replacing.
4. Lift up on the right side of the sink and lift the intake hose (which is inside the tank), and check
the strainer to see if it is clogged.
Temperature
Low
High
In Range
Thermister
Failure
Out of
Range**
To Float
Assembly
Fluid Temperature LED & Heater Chart
Light
Condition/Duration
Flash Slowly
On longer
Flash Slowly
On Shorter
Flash Very Slowly
On = Off
Flash Quickly
On 0.5 sec
Flash Quickly
On 0.5 sec
Status
LED's
D C B A
To Pump
To Power
To Low
Lamp
Fluid Lamp
Switch
ChemFree Technical Support • 1-800-521-7182
continued
On
Off
Off Shorter Should be ON
Off Longer
Should be Off
Off = On
Either On or Off
Off 0.5 sec Off
Off 0.5 sec Should Be Off / Constant on
indicates failure
Heater Status
Pump
AC IN
7
Tabla de contenido
