Hoover Power Scrub Elite Manual Del Usuario página 25

Maintenance:
BRUSHES: HOW TO CHANGE AND CLEAN
How to Remove
1. To prevent possible leaking, remove Clean Water Tank and
Dirty Water Tank.
2. With handle in upright position, tilt cleaner back until handle
rests on the floor.
3. Grab brush assembly and pull firmly (Fig. H).
4. The brushes can be cleaned under running water.
How to Replace
1. Align black posts on both ends of brush assembly with the slots
on the bottom of the cleaner.
2. Make sure that the hexagonal post (A) also aligns with the
hexagonal hole (B). Turn brushes slightly until post fits easily into
hole.
3. Press brush assembly firmly to snap into place.
CAUTION
!
To reduce the risk of injury from moving parts - Unplug before
connecting SpinScrub® Hand Tool. Not to be used for grooming pets.
Storage
Before storing: Empty Clean Water Tank and let air dry. Replace on
cleaner. Empty Dirty Water Tank, rinse tank and lid thoroughly with
clean water and let air dry.
Allow brushes and underside of carpet cleaner to air dry thoroughly
before storing carpet cleaner on a carpeted or wood surface.
Lubrication
!
The motor is equipped with bearings that contain sufficient lubrication
for the life of the motor.
The addition of lubricant could cause damage. Therefore, do not add
lubricant to motor bearings.
A
Fig.H
B
22