Optional Additional Settings; Modifying The "My" Favourite Heating Level; Adding/Removing Rts Control Points - SOMFY Heating Modulis Ramp RTS Manual De Instrucciones

Heating Modulis RTS Ramp
3) To switch on the "my" favourite heating level directly:
- Press the "my" button.
4) To increase the heating level:
- Press and hold the Up button:
The heating level increases as long as the button is held.
- Release the Up button when the required heating level is reached.
5) To reduce the heating level:
- Press and hold the Down button:
The heating level decreases as long as the button is held.
- Release the Down button when the required heating level is
reached.

7. Optional additional settings

7.1 Modifying the "My" favourite heating level

N.B.: The default factory setting for the favourite heating level on the
Heating Modulis RTS Ramp is 33% of maximum power. This favourite
position may be modifi ed as required.
7.1.1 From an RTS control point from the Modulis range
An RTS control point from the Modulis range has a thumbwheel for
settings.
1) Press the "My" button to switch on the heating lamp in the "my"
favourite position.
2) Move the thumbwheel to adjust the heating level according to requi-
rements: 33%, 66% or 100%.
3) Once the required heating level has been reached, press the
"my" button until the heating lamp switches on then off:
The new favourite heating level is programmed.
7.1.2 From a RTS control point or RTS Chronis
1) Press the "My" button to switch on the heating lamp in the "my"
favourite position.
2) Press and hold the up or down buttons to adjust the heating level as
required. 33%, 66% or 100%.
3) Once the required heating level has been reached, press
the "my" button until the heating lamp switches on then off:
The new favourite heating level is programmed.

7.2 Adding/Removing RTS control points

Caution! A maximum of 12 control points may be programmed into a
Heating Modulis RTS Ramp .
Note: Proceed in the same way to add or remove a control point.
1) Press the PROG button on the programmed RTS control point (a)
until the heating lamp comes on then goes out:
- The Heating Modulis RTS Ramp will be in its programming mode
for 2 minutes.
22
5061611X02_HMR_Ramp_RTS.indb 22
3
4
5
1
+
2
3
1
2
3
1
a
PROG.
Copyright © 2008 Somfy SAS. All rights reserved.
Installation guide
my
+
100%
66%
-
33%
+
100%
66%
-
33%
100%
66%
-
33%
100%
66%
33%
+
2
b
PROG.
2 min.
25/05/09 18:41:02