Power Inputs/Speaker Outputs; Amplifier Wiring; Power Connections; Speaker Wiring Diagram - Polk Audio PA D1000.1 Manual De Instrucciones

PA d1000.1 Power Inputs/Speaker Outputs
1 2 3 4
1. gNd (ground)—Connect this terminal directly to the metal chassis of the vehicle, using the shortest
wire necessary to make this connection. Always use wire of the same gauge or larger than the +12V power
wire . The chassis connection point should be scraped free of paint and dirt . Use only quality crimped and/or
soldered connectors at both ends of this wire . DO NOT connect this terminal directly to the vehicle battery
ground terminal or any other factory ground points .
2. rEm (remote Turn On)—This terminal turns on the amplifier when +12V is applied to it.
Connect it to the remote turn on lead of the head unit .
3. +12V Power—Connect this terminal through a FUSE or CIRCUIT BREAKER to the positive terminal
of the vehicle battery or the positive terminal of an isolated audio system battery .
WArNINg: Always protect this power wire by installing a fuse or circuit breaker of the appropriate
size within 12" of the battery terminal connection.
4. Fuse—These fuses (40A x 3) protect the amplifier against internal electrical damage and are meant
to protect only the amplifier . All other power connections should be fused at the power source .
5. Speaker Output—Connect your subwoofers here .
6. Terminal Adaptor—The adaptor enables the use of cable up to 0000AWG
for the ground and +12V connections (see illustration below).

AmPLIFIEr WIrINg

Power Connections

• PA D1000.1 Fuse Size: 3 x 40 AMP ATC.
• Power connections accept up to 4 AWG wire.
• 4 AWG power and ground wire recommended for optimal performance.
• Connect +12V to the battery through fuse holder. This connection provides
+12V main power to the amplifier.
• Power wire must be fused within 12" of the battery.
• Ground the amplifier using a good chassis ground as close as possible to the amplifier.
• Connect REM terminal to remote turn-on lead from the head unit. This connection
provides +12V power to turn-on the amplifier.
• Add extra ground wire between the negative terminal of the battery and the chassis.
6
5
6. Terminal Adaptor
© 2011 Polk Audio—all rights reserved
Speaker Wiring diagram PA d1000.1
The Polk Audio PA D1000 . 1 amplifier offers two positive and two negative output terminals for ease of connecting
1000.1
the speakers to the amplifier . Since this is a mono amplifier, connections are wired in paralleled internally .
The amplifier is stable to 1 Ohm .
1Ω min

AmPLIFIEr INSTALLATION

mounting Locations

The location of your amplifier will depend on several important issues . Due to the low profile and compact
2000.2
size of the Polk Audio PA D Series amplifier, there are many possible installation locations that will yield satisfactory
amplifier performance . Always mount the amplifier in a place that protects the amplifier from the elements .
In addition, mount the amplifier on a stable, flat surface .
NOTE: Mounting amplifiers upside down is not recommended and may cause premature thermal shutdown .
BRIDGED
WArNINg! DO NOT mOUNT any amplifier in the engine compartment . Amplifiers are not designed
to endure the harsh environment of an engine compartment .
GND REM 12V
L L R R 25A

Passenger Compartment

If you are going to mount the amplifier in the passenger compartment, make sure you have adequate room
for ventilation. When mounting your amplifier under a seat or similar area, keep a minimum of 1" of clearance
around the amplifier for adequate cooling .

Trunk Compartment

4Ω min
Mounting your amplifier in the trunk provides excellent performance as long as you do not restrict the airflow
around the heatsink of the amplifier . For optimal results, mount the amplifier with as much clearance as possible .
This type of mounting will yield the best cooling due to the convection effect of the amplifier chassis .
4000.4
RL RR FL FR
GND GND REM REM
© 2011 Polk Audio—all rights reserved
RL RR FL FR
2Ω min
2Ω min
BRIDGED
25A L L R R
2Ω min
2Ω min
RL RR FL FR
12V 12V
40A 40A 35A
RL RR FL FR
7