What To Expect; Clean And Store Me; How To Replace Your - Me Smooth Guia Del Usuario

what to expect

during treatment
You may feel a warming sensation during treatment. You should always start at
the Low elo ˉ s level and, if you are comfortable, increase to Medium or High for
even greater efficacy. If your skin should appear slightly red after treatment, this
should disappear within 24 hours.
full protocol
For best results, treat the target area once a week for 7 weeks. Use your
temporary hair removal solution in between treatments as you normally would.
After your initial protocol, use your me ˉ for touch ups of new hair growth as
needed.
Tips: When using the system on difficult to treat areas (e.g. underarm) apply the
applicator in 2 directions: left/right and up/down for full coverage.
clean and store me ˉ
• Turn off the system by pressing the power button on the base unit.
• Place the applicator in its cradle on the base unit.
• Unplug the electric cable from the electrical outlet.
• Clean the cartridge light output window with a non-alcohol based wipe or
soft tissue.
• Clean the outside surface of the me system using ONLY a dr y soft cloth or
a non-alcoholic based wet wipe.
Store the system in a cool and dry place AWAY from the reach of children.
•
13 EN
how to replace your elo ˉ s cartridge
When the cartridge life indicator light starts blinking on the base, that means
that you have 5% of the pulses remaining on your elo ˉ s cartridge. When the
indicator light is constant, your cartridge is empty and you need to replace it.
1
as needed
TOUCH 2
UPS
3
4
5
• Make sure that the me system is turned off and the cable is
unplugged from the electrical wall outlet (1).
• Remove the used cartridge from the applicator by holding the
cartridge´s sides and gently pulling it out. Dispose of the used
cartridge safely (2). Take the new cartridge out of its protective
container. Avoid touching the glass. Fingerprints or oils from your
skin can interfere with light passing through the glass, and this
will reduce the treatment success.
• Slide the new cartridge gently into the applicator until you
feel it "click" into place (3).
• Place the applicator in the cradle of the base unit before
turning on the me system (4).
• Turn on the me system. A new cartridge will show 100% on
the control panel. If cartridge is not properly inserted, the
percentage indicators on the base will blink (5).
EN 14