Tabla de contenido
BEFORE REQUESTING SERVICE
WARNING
Disconnect the electrical supply before servicing or cleaning the unit. Failure to do so
could result in electrical shock or personal injury from cleaner suddenly starting.
Review this chart to find do-it-yourself solutions for minor performance
problems. Any service needed, other than those described in these
Operating Instructions, should be performed by an authorized service
representative.
PROBLEM
Cleaner will
not run.
Poor job of dirt
pickup.
Dust escapes
the paper bag.
Light will
not work.
Dirt sensor will
not work.
Electrical Shock or Personal Injury Hazard.
POSSIBLE CAUSE
1. Unplugged at wall outlet.
2. ON-OFF switch not turned on.
3. Tripped thermal protector.
4. Tripped circuit breaker/blown
fuse at household service panel.
1. Full or clogged dust bag.
2. Broken belt.
3. Carpet-bare floor setting incorrect.
4. Clogged hose or nozzle.
5. Hose not inserted fully.
6. Worn agitator.
7. Hole in hose.
8. Dust cover improperly installed.
9. Belt not installed on motor shaft.
10. Floor cleaning attachment knob in 10. Rotate valve knob to floor
the cleaning attachment position
1. Bag improperly installed.
2. Bag torn.
1. Burned out light bulb.
1. Dirty optic cells.
POSSIBLE SOLUTION
1. Plug in firmly. Push ON-OFF
switch to ON.
2. Push ON-OFF switch to ON.
3. Unplug vacuum, wait thirty (30)
minutes, plug in and switch to ON.
4. Reset circuit breaker or replace
fuse.
1. Change bag.
2. Replace belt.
3. Set in the correct position.
4. Clean hose or nozzle area.
5. Insert hose.
6. Replace agitator.
7. Replace hose.
8. Properly install dust cover.
9. Install belt on motor shaft.
position.
1. Properly install bag.
2. Replace bag.
1. Replace light bulb.
1. Clean optic cells.
- 22 -
Tabla de contenido
