Worx LANDROID M Guia De Instalacion página 7

Connect the base to the boundary wire
IN
12
EN
IN
IN
OUT
1
Cut the end of the wire to a length that's appropriate convenient
for reaching the clamps.
Strip the two ends of the wire.
OUT
2
When connecting to the charging base there will be an IN-wire
and an OUT-wire, as shown.
Connect the IN-wire to the red clamp of the charging base and
the OUT-wire to the black clamp.
Then close the cover.
OUT
a
b
turn on and test the installation
This is the exciting part where you can turn your Landroid
3
You can now permanently fix the charging base on the ground
by pressing the supplied Base Retention Pegs with the supplied
Hex key.
NOTE: Make sure the IN-wire is running straight
underneath the center of the charging base.
4
Connect the power cord to the adaptor and then to the AC
electrical socket, the LED on the charging base will turn on. If
the LED is off, please refer to the Trouble shooting guide.When
connecting, align the notch on the power cord connector (a)
with the groove on the adaptor connector (b).
Make sure to only screw or unscrew the highlighted piece of
the connector.
If the green light does not come on, then check the power
connections.
In case the power cord is within the working area, you may bury
it as needed.
M on for the first time.
®
1
Place your Landroid M inside the
®
working area, a few meters from
the back of the charging base.
13
EN