Additional Features - Soundcast Melody Manual Del Usuario

Melody has a power boost feature
that lets you go above the maximum
standard volume level. This feature can
come in handy when you are playing a song
that was recorded with a very low level or need
additional volume. To activate this feature simply set
Melody to the maximum volume level by pressing and
holding the volume up button until the green LED blinks
once and the blue LED stops flashing. If at this point
you perform individual clicks on the button (up to 5 clicks)
you'll be able to increase the volume even more to give
your music the extra power that it needs. When you reach
the very maximum level, the LED will flash three times.
memory reset
Melody can memorize up to 6 Bluetooth devices. If you
need to reset the memory to make it forget all previously
paired devices, press and hold the Bluetooth button for
10 to12 seconds until you see the LED flash in green
and blue continuously, then release the button. At
this point Melody's memory has been erased and
is ready to be paired with a new device.

Additional Features

power Boost
12
switching Between
Bluetooth Devices
If Melody has been paired with more
than one Bluetooth device, you can switch
to another device with either of these two
methods:
method one:
1. Press the Bluetooth button once. The LED
will start flashing slowly.
2. Select "Melody" from the device list on
the Bluetooth device you want to connect
(which was previously paired to Melody).
method two:
1. Turn off Bluetooth on the connected device
(wait until you see your device has dropped
the connection).
2. Make sure the Bluetooth function is active
on the target device you want to connect.
3. Select "Melody" from the device list on the
target device.