Operating Instructions - Maxon PC-50 Manual Del Propietário

OPERATING INSTRUCTIONS

1) Install the PC-50's antenna by turning it clockwise
until finger-tight into the antenna receptacle on the top
of the unit. Do not over-tighten.
2) Remove the battery cover and install three (3) new
AA alkaline batteries. When placing the batteries in the
PC-50, the bottom (-) (flat side), of the battery rests on
the spring, and the battery's top (+) touches the battery
contact bar.
3) Turn the power on/off- volume control dial clock-
wise to a midway point to power the unit and set the
volume.
4) Move the channel selector knob to the desired
channel (A - E) to communicate with other 49 MHz
radio users on the same channel.
5) Use the Call button to send a 1 kHz tone signal
to alert second party you are calling. The red LED
will light when the button is pushed, indicating
the PC-50 is transmitting.
6) Hold the PC-50 about 2-3 inches from your mouth,
press the P-T-T button and speak into the microphone
to transmit. The red LED will light to indicate the
PC-50 is transmitting. Release the P-T-T button to
receive incoming signals.
NOTE: When transmitting (the P-T-T button is pressed)
you will override incoming signals. You will not be able
to receive a message when transmitting and you could
interrupt an incoming message if you accidently key
your P-T-T button.
6