Fuse Replacement - TechGrow Clima Micro Plus Manual

turn to 15 °C
•
turn to 35 °C
•
turn to 15 °C
•
turn to 35 °C
•
The next screen appears:
Temp 26c
Reset
The values have been reset. The main screen appears
after a few seconds.
Secondly, by completing the following steps:
1. The main screen is displayed:
Temp 26c
Set 27c
2. Put a precision screwdriver (or paper clip) in the
small round hole on the back of the Clima Micro
Plus Minimum Fan Speed and press just one time.
The next screen appears:
Temp 26c
Reset
The values have been reset. The main screen
appears after a few seconds.

5. Fuse replacement

If a short circuit occurs due to fan overload, the fuse will
blow. Even if the Clima Micro Plus Minimum Fan Speed
does not operate at all, in the worst case, this could
indicate a blown fuse. To replace the fuse you have to
open the Clima Micro Plus Minimum Fan Speed.
Complete the following steps:
1. Remove the plug from the socket.
2. Open the housing by unscrewing the 4 screws on
the back of the Clima Micro Plus Minimum Fan
Speed.
3. Locate the fuse and remove it.
4. Insert a new 5 amp fuse.
5. Screw the 4 screws to close the housing.
Your Clima Micro Plus Minimum Fan Speed is ready for
use again.
____________________________________________________________________________________________________________________________
TechGrow | Innovative Growing Solutions 12