Toto FBY1515LP#01 Manual Del Usario página 4

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Completing the Finished Wall
8
After connecting the drain to the trap add the finished wall.
Install tile or any finished wall material to provide a minimum gap of 2 mm (1/16") for contraction
and expansion. Seal with silicone.
Install the faucet trim according to the manufacturer's instructions.
Drop In
Silicone
WARNING: Do not use acidic or alkaline base products to clean the bathtub. Damage to
!
the enamel surface may occur.
Be sure to clean the bathtub after each use. Dirt may stain the bathtub if left for long periods.
Use neutral detergent, a soft cloth and a sponge. Follow only the installation instructions for your
particular model/installations.
Before using the bathtub place a small amount of cold water into the bathtub. Then add hot wa-
ter. If the hot water is 80 ºC (176 ºF) and used directly the bathtub can become damaged.
Avoid water containing sulfur. This will discolor the bathtub.
Installation (continued)
Silicone
Flat Rim Models
FBY1500, FBY1510,
FBY1550, FBY1700 and
FBY1800
Finished Surface
FBY1500, FBY1550, FBY1700 and
Cut finished surface to desired dimensions.
Dry fit to the bathtub.
Temporarily mark on the bathtub the edge of the opening of the finished surface.
Remove the finished surface and apply silicone to the bathtub (underneath the finished surface
location).
Replace the finished surface and secure it.
Add and/or remove silicone as desired.
Make sure the finished surface is not supported by the bathtub and is secured per local codes.
Bathtub Maintenance
Under Mount Models
FBY1800
Water resistant
Gypsum board
(green board)
Ceramic/Stone/Tile
Silicone
Tile In Flange Models
FBY1515, FBY1525 and FBY1715
Tabla de contenido
loading

Tabla de contenido