Important Notice - Stages cycling Power SPM1 Manual Del Usuario

Water resistance notice
The Stages® power meter is designed to provide excellent water resistance
and tested to resist water ingress to the IPX7 standard (up to 1 meter). This
provides outstanding water resistance for cycling conditions on-road and o ,
including stream crossing and heavy rain. Please keep in mind this is an
electronic device not a submarine; as such, there are limits to the water
resistance.
Do not subject the power meter to direct spray from a high pressure
sprayer. Water exiting a sprayer can reach hundreds and sometimes
thousands of pounds of pressure per square inch. This may be equivalent
to the pressure found at ocean depths of 1000 feet or more! It is possible
for water to be forced past the o-ring seal under these conditions and
damage to the electronics may occur.
Power meter (crank arm) installation
IMPORTANT NOTICE: to ensure power meter compatibility with the
frame and components, please follow these steps carefully and in the
speci c order. Do not install the pedals until compatibility of the power
meter has been con rmed.
1. Attach the left crank arm to the bike following the instructions provided
by the crank arm manufacturer and supplied with your power meter.
Links to crank manufacturer's installation instructions may be found at
the Stages Cycling website.
2. Carefully and fully install the crank arm onto the bike but
DO NOT ATTACH THE PEDAL AT THIS TIME.
3. Carefully and slowly rotate the crank 1 full revolution to ensure there
is no contact between the power meter sensor housing and any part
of the frame or other components as illustrated in FIG 7.
4. If there is interference between the power meter and the frame or other
components, contact your retailer for technical assistance.
5. If no interference is found you may continue with the nal installation of
pedals according to the pedal manufacturer's instructions.
5