Krups XP1000 Manual Del Usaurio página 14

KR_COFFEEMAKERS_ESPRESSO-XP1000_8080011304_Mise en page 1 18/06/12 09:45 P
Check that the appliance is unplugged and that there is no
contained pressure. (See CAUTION-PRESSURE).
Measure out a small amount of water and pour into tank. For
example: 2 oz (50 ml) of water to heat 4 oz (100 ml) of liquid.
Important: for maximum efficiency, avoid putting more than
4 oz (100 ml) of water into the tank.
Tightly screw on the boiler cap. Fig. 4.
Plug in the appliance.
Immerse the steam nozzle in the liquid to be heated.
Turn the knob to "steam" (b3). Fig. 10.
The ON/OFF pilot light will light up.
Steam is produced after 2 to 3 minutes of preheating.
Once the liquid is hot, turn selector knob back to "Off" (b1) and
unplug the appliance.
If you do not need all the water for steaming, proceed as follows:
Turn off the machine.
Release the remaining steam pressure into another container.
Before turning the knob again, turn the knob to "steam" (b3) to
remove any steam, take care to put a cup underneath the steam
nozzle.
CAUTION! Do not turn the selector knob back to "Off" (b1)
before all steam is released! (See CAUTION - PRESSURE).
ATTENTION! The plastic housing of the cappuccino nozzle
(g) has 2 fine holes at the top which draw air into the milk.
If those holes get clogged, the milk will not be frothed
properly. Therefore, do not dip the cappuccino nozzle in milk
or froth up to those holes.
ATTENTION! Immediately after use, wash the steam nozzle
with a damp sponge.
14