Idiomas disponibles
Idiomas disponibles
Device
Cover (C)
FIGURE 8
CAUTION
When a nonGFCI protected receptacle is used, the branch
circuit servicing the receptacle shall be GFCI protected.
2.4 Place the Deck Grommet™ Pro (A) into the deck
opening, position as shown in Figure 4. (see Figure 9).
2.4a The attached four Swing Clamps will ip out to grip the
underside of the deck board by tightening the four Swing
Clamps Screws (see Figure 10).
2.4b Tighten the Swing Clamp Screws (4) until the clamp
contacts the underside of the deck board. Finish tightening
the Swing Clamp Screws with an additional 1/2" turn to
secure Deck Grommet™ Pro (A) to the deck board
(see Figure 10). DO NOT OVER TIGHTEN!
2.4c Turn on electrical power to the circuit. Test function of the
GFCI protection according to the manufacturer's instructions.
INSERT
FIGURE 9
Wiring Chamber
Duplex
Receptacle
Installed
Duplex
Adapter (D)
Deck
Board
(4) Swing
Clamps
(Both Sides)
FIGURE 10
3. Opening Deck Grommet™ Pro & Plugging in Cord
3.1 Open Deck Grommet™ Pro's Cover by squeezing
the Latch inward (see Figure 8) and simultaneously
pulling using the Finger Hold and pivot open
(see Figure 11).
3.2 Insert the plug from the electrical cord into the
receptacle. Create a Drip Loop in the cord before
closing the Cover (see Figure 12).
3.3 Exit the Electrical Cord through the Cord Exit Slot
and shut cover ensuring the latch snaps shut
(see Figure 13).
Cover
FIGURE 11
Tighten
Swing
Clamp
Screws (4)
Finger Hold
Latch
Squeeze
Latch Inward
TA04771-1 A Page 3 of 4
