ABB Red Dot Deck Grommet Pro DKG-PRO Instrucciones De Instalación

The Deck Grommet™ Pro accommodates a minimum deck ooring thickness of 7/8" to a maximum of 1-5/8" and a
minimum width of 5-1/4". The deck ooring must be a minimum of 2 feet above ground surface.
WARNING
• For outdoor use only.
• Use this product only for its intended use as
described in this installation instruction.
• DO NOT install in line with a power converter.
• DO NOT use attachments not recommended by
manufacturer.
• DO NOT insert foreign objects into power outlet
receptacles.
• DO NOT attempt to repair if any malfunction
occurs.
• Used for mounting on deck board materials only.
• This product (as supplied) has no eld serviceable parts.
Deck Grommet™ Pro Includes:
(Parts List)
A. (1) Deck Grommet
B. (1) Cut-Out Template
C. (1) Device Cover Plate
D. (1) Duplex Receptacle Adapter
E. (2) Flexible Cord Connector
F. (1) 3 Wire Flexible Cord
Type SJOOW (3 feet, one end
stripped, one end unstripped)
B C D
Required Items
(Not Included)
Weatherproof outlet box and cover
(Red•Dot Cat. Nos. IH3-1 (Box) & CCB (Cover) recommended)
GFCI or Standard Duplex Receptacle - Weather
Resistant (WR) and Tamper Resistant (TR)
TA04771-1 A Page 1 of 4
INSTALLATION INSTRUCTIONS
for The Deck Grommet™ Pro
Catalog Number DKG-PRO
A
E
F
RISK OF SHOCK, DISCONNECT
POWER BEFORE INSTALLATION.
CAUTION
The Deck Grommet™ Pro shall be installed by a
quali ed electrician in accordance with the National
and Local Electrical Codes.
INSTALLATION INSTRUCTIONS:
1. Cut-out Instructions
1.1 Select the deck location where the Deck
Grommet™ Pro will be installed.
1.2 IMPORTANT: Be sure that there are no obstructions
under the deck ooring before any cut-out is made.
Deck ooring must be a minimum of 2 feet above
ground surface (see Figure 1).
1.3 Position the Cut-Out Template (B) (supplied)
centrally between the width (5-1/4" min.) of one of
the deck boards and a minimum of 2" away from
the joist (see Figure 1).
1.4 When positioned, trace the cut-out shape onto
the deck board (see Figure 2).
1.5 Drill 1/2" diameter starter hole along the inside
edge of the traced cut-out and use a jig saw to
cut the outlined shape through the deck surface.
Cut-Out Template
centrally between
Deck Boards
Joist
(both sides)
Shows three different ways to
FIGURE 1
position the cut-out template.
Trace around Cut-Out
Template
FIGURE 2
WARNING
English
2' min. from ground
2" minimum
away from joist
(Typical - both sides)