Before Startup - Windsor Radius 30 Manual Del Usuario

Open the device hood.
Note
The hood is unlocked with the same key as
the main switch. The key can be removed
now, when the hood is unlocked.
Insert the key for the main switch into
the hood lock and rotate in a clockwise
direction by 90°.
Pull the hood lock out by the key.
Open the device hood.
Close device hood
Close cover.
Close the device hood with the main
switch key.

Before Startup

Unloading
To unload the machine, proceed as follows:
Remove the cardboard.
Remove the wooden blocks that secure
the wheels and raise the device from
the pallette by hand.
Release parking brake.
Installing the pushing handle
Loosen the fastening screws.
Align the pushing handle.
Tighten the fastening screws.
Install side brush
Note
Remove the waste container and move the
pushing handle to the front prior to tilting
the appliance. Do not rest the appliance on
the pushing handle.
Clip side brush on to driver and screw
on.
Batteries
Safety notes regarding the batteries
Please observe the following warning notes
when handling batteries:
Observe the directions on the
battery, in the instructions for
use and in the vehicle operat-
ing instructions!
Wear an eye shield!
Keep away children from acid
and batteries!
Risk of explosion!
Fire, sparks, open light, and
smoking not allowed!
Danger of caustic material!
First aid!
Warning note!
Disposal!
Do not throw the battery in the
trash bin!
Danger
Risk of explosion! Do not put tools or similar
on the battery, i.e. on the terminal poles
and cell connectors.
Danger
Risk of injury! Ensure that wounds never
come into contact with lead. Always clean
your hands after having worked with batter-
ies.
Danger
Risk of fire and explosion!
– Smoking and naked flames are strictly
prohibited.
– Rooms where batteries are charged
must have good ventilation because
highly explosive gas is emitted during
charging.
Danger
Danger of cautic material!
– Rinse thoroughly with lots of clear water
if acid gets into the eye or comes in con-
tact with the skin.
– Then consult a doctor immediately.
– Wash off the acid If it comes in contact
with the clothes.
Installing and connecting the batteries
Open the device hood.
Set the batteries on to the motor carrier.
Secure the batteries with the holding
strap.
Warning
Pay attention to correct poles.
Connect pole terminal (red cable) to
positive pole (+).
Fit the connection wires to the batteries.
Connect pole terminal to negative pole
(-).
Note
Before removing the battery, make sure
that the negative pole lead is disconnected.
Check that the battery pole and pole termi-
nals are adequately protected with pole
grease.
Warning
Charge the batteries before commissioning
the machine.
Charge the batteries
Danger
Risk of electric shock. Observe supply net-
work and fuse protection. Only use the
charger in dry rooms with sufficient ventila-
tion.
Danger
Risk of injury! Comply with safety regula-
tions on the handling of batteries. Observe
the directions provided by the manufacturer
of the charger.
Danger
Risk of injury! The charger should be used
only if the mains cable is in an undamaged
state. Get the manufacturer, the customer
service agent or a qualified person to im-
mediately replace a damaged mains cable.
Note
Normally, the machine is equipped with
maintenance-free batteries.
Open the device hood.
Insert the plug of the charger into the
socket.
Note
The charger has electronic controls and au-
tomatically switches off the charging pro-
cess. All functions of the machine are
automatically shut down during the charg-
ing process.
The battery display shows the progress of
the charging process when the plug is in-
serted:
Batteries are being glows yellow
charged
Batteries are charged glows green
9
English