ENGLISH
MANUAL installation:
Don't yet connect the DLP-6 MK2 to your PC!
The installation file for the driver can be found on the supplied CDROM or you can download it from
the SYNQ-website (see download section of the DLP-6 MK2 product page).
UNZIP the file and double-click the exe-file named "PL-2303 Driver Installer.exe" and follow the
instructions to install the driver properly.
To check if the driver is installed, open the Windows
device manager and check if the driver is available, you
can also check which COM-port is emulated (in most
cases it will be COM3, as shown on the picture) To be
able to see the driver listed, you should connect the DLP-
6 MK2 to your PC and turn it on.
Remark: depending on the hardware inside your DLP-6
MK2 the drivername shown in windows can be different!
Part2 – installing the DLP-6 MK2 PC-software
The DLP-6 MK2 PC-software can be found on the supplied CDROM or you can download it from the
SYNQ-website (see download section of the DLP-6 MK2 product page).
Double-click the file named "DigitalSpeakerSetup_V110 SYNQ Audio.exe" and follow the instructions to
install the software.
Part3 – first time use
First connect the DLP-6 MK2 with your PC via USB or RS485.
The USB output of the PC will be treated by the software as an RS-232 connection. Therefore you will
have to set the correct RS232 port when you use the software for the first time:
Start the PC software. In the left upper corner you will notice the sign on the right, indicating
that the software is not connected to the processor.
Open the "CONFIG" menu and select the "RS-232" option.
Normally you should choose "COM3". To be sure you can check the COM-port in the Windows
manager.
Open the "CONFIG" menu again and select "OnLine": a popup window will open where you have to
select "DLP-6 MK2:2In6Out"
If the software can connect to the processor than you should see the sign on the right. If this
doesn't work, you should also select some other COM-settings and try again to establish a
connection.
CHECKING THE SOFTWARE VERSION
Open the "HELP" menu and select the "About" option. In the popup window you can see the software
version and program build:
SYNQ
®
®
11/96
OPERATION MANUAL
DLP-6 MK2
®
device