Klarstein Vinsider 36 Built-in Duo Manual De Instrucciones página 25

3. Power on
The appliance can now be switched on and will have sufficiently cooled down inside
after 1 hour, otherwise you should check the power connection.
Plug in and switch on the cooler by pressing on the power button for a few seconds.
When you use the wine cooler for the first time (or restart the wine cooler after having it
shut off for a long time), there will be a few degrees variance between the temperature
you have selected and the one indicated on the LED readout. This is normal and it is
due to the length of the activation time. Once the wine cooler is running for a few hours
everything will stabilize.
Note: If the unit is unplugged, power is lost, or turned off, wait 3 to 5 minutes before
restarting the unit. The wine cooler will not start if you attempt to restart before this
time delay.
Operating noises
To reach the desired temperature settings, wine coolers, like all wine coolers operating
with compressors and fans, may produce the following types of noises. These noises are
normal and may occur as follows:
• Gurgling sound - caused by the refrigerant flowing through the appliance's coils.
• Cracking/popping sounds - resulting from the contraction and expansion of the
refrigerant gas to produce cold.
• Fan operating sound - to circulate the air within the wine cooler.
Loading the wine cooler
• Do remove or relocate adjustable wooden shelves to accommodate larger type
of bottles or increase the capacity of the cooler by stacking the bottles up when
necessary.
• Keep smalls gap between the walls and the bottles to allow air circulation. Like an
underground cooler air circulation is important to prevent mould and for a better
homogeneous temperature within the cooler.
• Do not over load your wine cooler to facilitate air circulation.
• Avoid obstructing the internal fans (located inside on the back panel of the wine cooler).
• Do not slide the shelves outwards beyond the fixed position to prevent the bottles from falling.
• Do not pull out more than one loaded shelf at a time as this may cause the wine
cooler to tilt forward.
• Do not cover the wooden shelves with alloy foil or other materials, as it will obstruct
air circulation.
• Do not move your wine cooler while it is loaded with wines. This might distort the
body of the wine cooler and cause back injury.
EN
25