Indel B FM7 BACK Instrucciones De Uso página 30

FM 7
SA FE T Y WA R N I N G S D U R I N G U S E
Attention
Strictly follow the indications given below:
• Keep and use the device away from children.
• Protect the device and cables from excessive heat and from moisture.
• Disconnect the device from the power supply battery when recharging the battery, as overvoltage
may damage it.
• If the device is not used for a long time, disconnect it from the battery and dry the internal compartment.
IN S TALL ATIO N
Carefully read and comply with the following instructions, to perform a correct installation of the
device in a proper way and to avoid risks to the installer and to any third party.
C H EC K I N G TH E R EC E IVE D G O O D S
In presence of the carrier, inspect the goods received for its integrity and state.
Check the correspondence between the contents of the delivery and the items listed in the delivery bill.
In case of discrepancies and/or damages detected, claim the situation to the carrier.
NOTE: According to the national and international laws, goods are always travelling at consignee's risk.
If not otherwise stated in the contract, goods are transported without assurance, at consignee's risk. Any
claim due to damages suffered during the shipment, transportation, unloading and unpacking of the
device may not be imputed to the Manufacturer.
I N S TA LL ATI O N WA R N I N G
Follow the indications given below for
proper set-up and selection of the installation site:
• Do not install the device next to heat sources like
heating elements, electric ovens and gas ovens,
hot water pipes.
• Install the device in a dry and protected place.
• Install the device so that hot air produced by the
cooling circuit can be freely dissipated. Therefore,
ensure adequate ventilation
distances from the retaining walls, indicated in the
figure below.
• Install the device so that the refrigerating unit is
inaccessible to every unauthorized user. When the
refrigerating unit is operating, its components may
get overheated and create a danger for the user.
• The device shouldn't share the electric power
supply line with other equipment able to create
overvoltage peaks in a fast and destroying way. In
an ideal condition, the device should be supplied
FM7 REV. 01 - FEBRUARY 2019
min. 50 mm
respecting the
28
min. 30 mm