Klarstein 10029239 Manual Del Usuario página 27

To start cooking
1. Touch the ON/OFF control. After power on, the buzzer beeps once, all displays show " – " or " – – ", indica-
ting that the induction hob has entered the state of standby mode.
2. Place a suitable pan on the cooking zone that you wish to use. Make sure the bottom of the pan and the
surface Of the cooking zone are clean and dry.
3. Touching the heating zone selection control ,and a indicator next to the key will flash.
4. Select a heat setting by touching the „-" or „+" control. If you don't choose a heating zone in 1 minute, the
induction hob will automatically switch off. You will need to start again at step 1. You can modify the heat
setting at any time during cooking.
When you have finished cooking
1. Turn the cooking zone off by scrolling down „-" to "0". Make sure the display show "0".
2. Turn the whole cooktop off by touching the ON/OFF control.
3. Beware of hot surfaces! "H" will show which cooking zone is hot to touch. It will disappear when the surface
has cooled down to a safe temperature. It can also be used as an energy saving function if you want to heat
further pans, use the hotplate that is still hot.
Using the Timer
You can use the timer in two different ways:
• You can use it as a minute minder. In this case, the timer will not turn any cooking zone off when the set
time is up.
• You can set it to turn one cooking zone off after the set time is up.
• You can set the timer up to 99 minutes.
Using the Timer as a Minute Minder
1. Make sure the cooktop is turned on. Note: you can use the minute minder even if you're not selecting any
cooking zone.
2. Touch the Timer key.
3. Set the time by touching the „+/-" control of the timer. Hint: Touch the „+/-" control of the timer once to
decrease or increase by 1 minute. Hold the „+/-" control of the timer to decrease or increase by 10 minutes.
Scrolling the „-" to the "00",the timer is cancelled.
4. When the time is set, it will begin to count down immediately. The display will show the remaining time and
the timer indicator will flash for 5 seconds.
5. Buzzer will beeps for 30 seconds and the timer indicator shows "- - " when the setting time finished.
27
Operation Item 10029239