Fire Sense 1031510 Manual De Instrucciones página 12

OPERATING INSTRUCTIONS
lIGHTING
NOTE: For initial start or after any cylinder
change, hold the control knob in for 2
minutes to purge air from all gas lines
before proceeding.
1. Turn the control knob to the "OFF"
position.
2. Fully open the LP cylinder valve.
3. Push in and turn the control knob
to HI.
4. While holding control knob in, push
the RED igniter button to ignite the
main burner.
5. To decrease the flame, turn the control
knob counter clockwise towards LO.
To increase the flame, turn the control
knob clockwise to HI.
6. To turn the appliance OFF, push in the
control knob and turn clockwise to the
OFF position.
7. Wait at least 5 minutes before
attempting to re-light the heater.
8. Turn the gas cylinder valve to OFF
or closed.
If you experience any ignition
problems, please consult
"Troubleshooting" on page 14.
Caution: Avoid inhaling fumes
emitted from the heater's first use.
Smoke and odor from the burning
of oils used in the manufacturing
will appear. Both smoke and odor
will dissipate after approximately
30 minutes. The heater should
NOT produce thick black smoke.
Contact us for assistance: (866) 985-7877 | www.wtliving.com
FOR YOUR SAFETY
Be careful when attempting to manually
PUSH IN
ignite this heater. Holding in the control
knob for more than 10 seconds before
igniting the gas will cause a ball of flame
upon ignition.
WHEN HEATER IS ON:
Emitter screen will become bright
red due to intense heat. The color
is more visible at night. Burner will
display tongues of blue and yellow
flames. These flames should not
be yellow or produce thick black
PUSH &
smoke, indicating an obstruction
HOlD
of airflow through the burners. The
flame should be blue with straight
yellow tops. If excessive yellow
WHIlE
flame is detected, turn off heater
and consult "Troubleshooting" on
PUSHING
page 14.
IN BUTTON
RE-lIGHTING:
Note: For your safety, the control
knob cannot be turned OFF
without first depressing the
control knob and then rotating
to OFF.
1. Turn control knob to OFF.
2. Wait at least 5 minutes to
allow gas to dissipate before
re-lighting.
3. Repeat the "Lighting" steps
listed above.
WARNING
12