Configuration; Programming And Signal Selection - Chauvet DJ D-Fi Hub Guía De Referencia Rápida

D-Fi™ Hub QRG

Configuration

Programming and
Signal Selection
The D-Fi™ Hub can be used two ways:
·
It can be connected to any DMX controller and transmit to
D-Fi™-compatible lights.
·
It can be connected to any DMX lights and receive from a D-Fi™-compatible
controller.
To connect the D-Fi™ Hub to a DMX controller and configure it to transmit to
D-Fi™-compatible lights, do the following:
1. Connect the hub to the controller using a DMX cable.
2. Connect the hub to power.
3. If the display shows Transmit Manual <CHXX>, where XX is a value
between 01 and 16, the hub is already configured for manual transmission.
4. Press <MENU> and the display shows Settings with 2 words underneath.
5. Press <ENTER> and the 2 words become highlighted.
6. Use <UP> or <DOWN> to cycle through the highlighted options until the
display shows Transmit Manual.
Note: Selecting Transmit Auto automatically detects a transmission signal
when used in conjunction with <AUTO SYNC>.
7. Press <ENTER> and the display shows Transmit Manual with <CHXX>
highlighted, where XX is a value between 01 and 16.
8. Use <UP> or <DOWN> to cycle through the highlighted channel options
and select the channel to use for D-Fi™ transmission.
9. Press <ENTER> and the display shows Transmit Manual <CHXX>, where
XX is the channel selected in step 8.
The hub is now configured for manual signal transmission.
NOTE: All the lights must be set to the D-Fi™ channel shown on the hub's
display.
To connect the D-Fi™ Hub to any DMX lights and configure it to receive D-Fi™
signals from a D-Fi™-compatible hub, do the following:
1. Connect the hub to the lights using a DMX cable.
2. Connect the hub to power.
3. If the display shows Receive Manual <CHXX>, where XX is a value
between 01 and 16, the hub is already configured for manual reception.
4. Press <MENU> and the display shows Settings with 2 words underneath
5. Press <ENTER> and the 2 words become highlighted.
6. Use <UP> or <DOWN> to cycle through the highlighted options until the
display shows Receive Manual.
Note: Selecting Receive Auto automatically detects a receiving signal when
used in conjunction with <AUTO SYNC>.
7. Press <ENTER> and the display shows Receive Manual with <CHXX>
highlighted, where XX is a value between 01 and 16.
8. Use <UP> or <DOWN> to cycle through the highlighted channel options
and select the channel to use for D-Fi™ reception.
9. Press <ENTER> and the display shows Receive Manual <CHXX>, where
XX is the channel number selected in step 8.
The hub is now configured for manual signal reception.
NOTE: The controller must be set to the D-Fi™ channel shown on the hub's
display.
Information about using D-Fi™ lights and controllers is in the product manuals at
the Chauvet website: http://www.chauvetlighting.com/product-manuals-literature/.
Information about
http://www.chauvetlighting.com/downloads/DMX_Primer_rev05_WO.pdf.
DMX is in the
6
Chauvet DMX Primer
EN
at: