Management Via Control Panel; Ai Key - Choice Of The Welding Process - Cebora 208.00 Manual De Istrucciones

CEBORA S.p.A.
4

MANAGEMENT VIA CONTROL PANEL.

Control Panel operations depend on the status of the "Robot" function in the "Second Functions" menu
(par. 7.1).
With the "Robot" function disabled (rob OFF) the Control Panel maintains full management of the
Welding System (except for the welding command, Arc-on signal, which must always be provided by the
Robot Terminal).
With the "Robot" function enabled (rob On), operation of the system switches to the Robot Terminal and
the Control Panel maintains partial operation.
NOTE: This Instruction Manual refers to the Control Panel art. 208 in Robot applications. Only operation
with the "Robot" function active (rob On) is described below.
The status of the "Robot" function is indicated by the led AT (fig. 2):

led AT off

led AT flashing
With the "Robot" function active (rob On), Control Panel operations depend on the selected Operating
Mode (par. 3.1).
The commands and signals based on this selection are described below.
GB
4.1

AI key - Choice of the welding process.

Operative in Parameter selection internal mode.
Each time the key is pressed selects a different welding process.
The process selected is indicated by the lighting of the corresponding led.
Led R1 Pulsed Synergic MIG/MAG Process.
Led R2 Non-pulsed Synergic MIG/MAG Process.
Led R3 Conventional MIG/MAG process.
Led R4 TIG Process (not available).
Led R5 MMA process (not available).
3.300.162-C
= "Robot" function not active (rob OFF).
= "Robot" function active (rob On).
fig. 2
26
04/03/2016