Bulb Replacement - Heath Zenith DualBrite 5512 Guia De Inicio Rapido

Light Shield Installation
If your light does not come on at dusk or turns off un-
expectedly, then another light source may be activating
the daytime shutoff feature. Possible sources of light
interference are street lights, landscape lighting, other
security lights or lanterns, or an interior house light shin-
ing through a window. It could also be reflective light,
such as from a pool or light colored wall.
To install the light shield, follow these simple steps.
1. Remove protective backing from the bottom of the
light shield.
2. Position light shield over the photocell with the
opening facing away from the interfering light.
3. Press the adhesive side firmly against the photocell
to mount it permanently in place.
Light
Shield
204057-01
CAUTION: When replacing bulbs, turn power
off and let the fixture cool.
Important: Use a clean glove or cloth when handling
the new bulb. Use isopropyl (rubbing) alcohol to clean
the bulb if it is touched with your bare hands.
1. Open lamp head with a phillips head screwdriver.
To remove the old bulb, push the bulb towards the
right until the left side of the bulb is clear of the left
socket.
2. To install the bulb, place one end of the bulb on the
contact in the right socket. While pushing the bulb
against the right contact, lower the other end of the
bulb onto the contact in the left socket.
3. Spin the bulb to verify it is seated properly.
Protective
4. Close the lamp head and tighten locking screw
Backing
securely.
Left
Socket
Contact
5

Bulb Replacement

Bulb
1
2
Lamp Head
Right
Socket
Glass
Cover