DENTAURUM CONTEC lcr Modo De Empleo página 13

The above-mentioned curing times are valid for polymerization
„ „
lamps with a light intensity of at least 700 mW / cm². The light-curing
time may vary depending on the source of light and instructions
for use. The wavelength of the lamp must cover the range of
400 – 500 nm.
Make sure the material is at room temperature before it is used.
„ „
CONTEC lcr disposable tubes (REF 163-120-00) are intended for
„ „
single use only and should be disposed of after each application.
Close the lid of the syringe after use.
Standard medical gloves do not offer protection against the
„ „
sensitizing effect of methacrylate. Should the product come into
contact with the glove, remove the glove and dispose of it. Wash
your hands immediately with soap and water and put on new
gloves. Contact your doctor if you experience an allergic reaction.
10. Storage
Protect light-curing products from strong light or intense heat.
CONTEC lcr has been developed for use at room temperature (20 – 25 °C
/ 68 – 77 °F). Store at 4 – 28 °C (39 – 82 °F). Light sensitive. If the room
temperature exceeds 28 °C (82 °F), store the product in a refrigerator.
Do not deep-freeze!
EN
13