Getting Starteda - Xoro HTC1900D Manual De Operación

Getting Started
Please note that you need to set the remote control to the right mode when using this device.
In mode Analog-TV, SCART, PC-RGB, AV, S-Video, the remote control must be set to mode
TV.
In mode DVD, DVB-T, USB, Cardreader, the remote control must be set to mode DVD.
1. Connect the aerial or input source to the appropriate input socket at the rear of the set.
(see page 6).
2. Connect the small round plug on the power adaptor cable to the power input socket at
the rear of the set.
3. Connect the mains cable between the power adapter and the mains supply.
4. Switch the power on by pressing the POWER button on the front panel or the remote
control the LED will show green.
5. Use the AV button on the front panel or the remote control to select which input source
to use :TV, PC-RGB, AV, S-video, Scart or DVD.
You can use the front panel control to adjust the volume or select a channel, as shown
below, or you may use the remote control (see page 8).
6. To switch the set off a short time, press the POWER button, the set will go into standby
and the LED will show red . lf you are not going to use the set for some time, switch the
power off completely by unplugging the mains cable .
Open/Close
PLAY
Menu
CONNECTING UP
STOP
Volume adjust:
Vol ADD
Vol Calando
Remote Control
Window keep clear
AV / TV: Source
Channel (program)
PRO UP
PRO DOWN
Power
7