HAMPTON BAY Monte Carlo Serie Manual De Instrucciones página 6

ASSEMBLY AND INSTALLATION INSTRUCTIONS:
1. Shut down the main electrical supply from the fuse box or circuit breaker in your house or building.
2. Fasten the mounting strip onto the outlet box using 2 outlet box screws.
3. Thread the G1/2 inch threaded tube into center hole of mounting strip about 4 complete turns. Lock in
place with lock washer and hex nut. The G1/2 inch threaded tube should extend long enough to protrude
through the canopy when it is mounted. Adjust as necessary.
4. Guide the fixture wire with bare copper grounding wire through the crystal column and loop, screw the
crystal column into bushing on the fixture body securely.
5. Adjust all arms to make an equal distance between arms.
6. Using a pair of pliers, twist open one chain link at the end of chain links. Hook it to the loop and close the
chain link. Place a piece of cloth between the jaws of pliers and the chain link to prevent scratching the
finish.
7. Tighten the screw collar loop to the G1/2 inch threaded tube on the mounting strip. Place the ring and
canopy over the chain on the fixture. Using pliers, twist open the chain link at the other end of the chain.
Hook the whole fixture to the screw collar loop on the ceiling and close the chain link
8. Weave the fixture wires and bare copper ground wire up through the chain links, ring, canopy, screw
collar loop and the threaded tube in the mounting strip and then into outlet box. Position both the supply
wires and the fixture wires outside of the outlet box to facilitate connection.
9. Connect the wire from the fixture to the power supply wire from outlet box. Cover with wire connectors.
A. Twist together glossy / live wire from the fixture with black wire from outlet box. Cover with wire
connector.
B. Twist together rough / neutral wire from the fixture with white wire from outlet box. Cover with wire
connector.
C. The bare copper grounding wire from the fixture must loop one turn under the head of green screw
on mounting strip before it is connected to the grounding conductor of the supply circuit.
Note: The Glossy/Live wire has the text printed on it; the Rough/Neutral wire has the ridge on it.
10. Carefully position all wiring inside outlet box.
11. Place the canopy all the way to the ceiling and tighten the ring onto the screw collar loop until the canopy
is firmly held against the ceiling.
12. Thread the G3/8 inch threaded tube into the bottom of fixture body, place the big cap over G3/8 inch
threaded tube and secure by tightening the finial with crystal drop.
13. Place the caps onto each socket.
14. Install the bulbs (not included). Use 60-watt Maximum Candelabra base type B bulb or MAX 13W UL
LISTED CFL bulb.
15. Turn on the electrical power in your house or building to activate the chandelier.
6