Dohle Duplocoll Manual De Instrucciones página 11

The compatibility with directly or indirectly contacted material has to be tested in
advance.
C. Preparation
The temperature of tape and glass and ideally the ambient temperature shall be
between 18°C and 35°C in order to achieve the best final adhesion.
The glass surface must be clean, dry and grease-free. Therefore it has to be cleaned
with an adequate cleaner (Bohle Special Cleaner BO 51 079 11) using lint-free, clean
wiping cloth.
The adhesive tape has to be checked visually for damages of the bonding area and
the detaching of the liner before application.
D. Application
We recommend to use the tape applicator in order to ensure a linear application,
withhout tension and bubbles. Please run the following steps:
1. Position the tape at the beginning of
the glass edge and bond it manually
2 to 3 cm along the glass.
2. Position the applicator on top of to the
covered side of the tape. Ensure that
you apply the tape to the bonding
surface at a sharp angle.
3. Move the tape applicator along the
glass. If required, press it very slightly
onto the glass.
EN
11