Wt800 Quick Start - Eden World Tour Serie Guia De Inicio Rapido

E D E N | W O R L D T O U R S E R I E S | W T 8 0 0 - 7
WT800 Front Panel Navigation:
1. Eden logo: Illuminates when unit is switched on.
2. Input: Connect your instrument to the amplifier here.
3. Gain control: Use this to set the input level for the amplifier
to suit your instrument. Pull this control to activate the
mute feature.
4. Set level indicator: Use this to help set your input signal
level this should illuminate on your loudest/lowest notes.
5. Enhance: Providing Eden tone shaping use this control to
increase the amount of proprietary EQ sweep in your sound.
6. Input PAD indicator: Illuminates when input pad is active.
7. Input PAD switch: This control activates the input pad
feature reduces input signal level by -10DB.
8. Bass: Use this control to increase or decrease the underlying
bass tone of the amplifier.
9. Low frequency control: Use this low frequency selector to
determine where in the low frequency range you cut or boost
your sound.
10. Low level control: Use this control to select the amount of
cut or boost you require at your required frequency.
11. Mid frequency control: Use this Mid frequency selector to
determine where in the mid frequency range you cut or boost
your sound.
12. Mid level control: Use this control to select the amount of
cut or boost you require at your required frequency.
1 4 | H I F I D E L I T Y F O R L O W F R E Q U E N C Y
WT800 Quick Start Guide
13. High frequency control: Use this High frequency selector
14. High level control: Use this control to select the amount of
15. Compressor switch: Toggles compression off / on.
16. Treble: Use this control to increase or decrease the overall
17. Compressor indicator: This illuminates when compressor
18. EQ Clip indicator: Illuminates when EQ is being clipped.
19. Master: Controls the overall output level (volume) of
20. Bi-Amp Mode Switch: Turns Bi-Amp mode off/on.
21. Balance control: Controls the output power for each side of
22. Crossover control: Controls the crossover point between
23. Bridged mono: Turns Bridged Mono feature on / off.
to determine where in the High frequency range you cut or
boost your sound.
cut or boost you require at your required frequency.
treble level of the amplifier.
is on.
the amplifier.
BEFORE USING THIS FEATURE PLEASE READ AND
UNDERSTAND THE "BEFORE YOU PLUG IN" SECTION
OF THIS GUIDE!
the amplifier.
each amplifier (Bi-Amp Mode Only).
BEFORE USING THIS FEATURE PLEASE READ AND
UNDERSTAND THE "BEFORE YOU PLUG IN" SECTION
OF THIS GUIDE!