Changing Wire Settings - Blue Hawk FLUX-MIG 100 Manual Del Usuario

ASSEMBLY INSTRUCTIONS
It's recommended that the welding wire have a clean, straight cut at the end which will be fed
through the wire feed assembly. Cut off the end of the welding wire with a pair of wire cutters
(not included) to remove any burs, sharp edges, and/or crimps or bends in welding wire. The
manufacturer recommends cutting at least 3 inches from the welding wire to ensure a clean
straight cut.
Attach the plastic protective cap (J) over the feed wheel (K). Turn the
plastic protective cap (J) so that the opening is facing the swing arm (H)
when closed and the opening will allow the welding wire to feed through
the wire feed assembly.
Feed welding wire through feed tube (I) and along the top groove of feed
wheel (K).
Continue to feed welding wire through and into the feed wire inlet (L).
Once the wire has been fed into the wire feed inlet (L), close the swing
arm (H) and then lower tension arm and slightly tighten adjustment
knob (G).
Unscrew and remove the gun nozzle cup and contact tip (E). Lay out the
torch cable straight. Turn power switch ON and press trigger on the
welding gun to feed wire through the torch cable (C).
NOTE: When unscrewing the gun nozzle cup (E), make sure you do not
damage the ceramic ring at the base of the gun nozzle. Always place gun
nozzle cup in secure place where it can not get damaged.
Make sure the welding wire is being fed through the wire feed assembly properly, and that the
feed wheel and welding spool are both spinning and that the welding wire is not pressed flat. If the
welding wire is being pressed flat, stop the machine and loosen the tension on the tension
adjustment knob. Continue to feed wire through while making sure it's not being pressed flat.
Once the welding wire is past the welding nozzle tip, turn power off to unit and screw on the
contact tip so that you can properly check the welding wire tension before welding.
10
6
J
K
H
7
I
K
8
9
1
2
H
10
C
CONTACT TIP
NOZZLE
www.lowes.com
G
E
®