Eia-232 Commands Of Hm6050-2; Setting Into Operation - Hameg Instruments HM6050-2 Manual De Instrucciones

Pin #
2
3
5
9
The standard voltage level at the Tx, Rx terminals is ± 12Volts. Interface
configuration:
9600 baud
8 data bits
2 stop bits
no hardware protocol

EIA-232 Commands of HM6050-2

The LISN interprets the following remote control commands.
Please consider the lower/upper case letters.
Command
R
O
P
p
N
n
L
l

Setting into operation

Read the operator's manual before setting up the HM6050-2!
Only qualified personnel are allowed to set up the LISN for operation.
HM6050-2 has been designed in conformity to regulations VDE 9876 and
CISPR Publ. 16. The leakage current of the instrument exceeds the
allowed value of 0,5 mA
operating measurement instruments. Thus, the safety requirements
have to be accomplished by additional provisions according to IEC364-
4-41 (CENELEC HD 384.4.41 and VDE 0100 Part 410). Due to the circuitry
of the HM6050-2 a maximum leakage current of 800 mA can occur.
28
Tx Data (data from LISN to computer)
Rx Data (data from computer to LISN)
Ground
+5V supply voltage for external devices
(max. 30mA).
Function
Remote control enabled
Local control
Protect. ground line sim. circuit on
Protect. ground line sim. circuit off
(bypass)
EMC test signal of line N
EMC test signal of line L1
Transient Limiter off
Transient Limiter activated
as defined in IEC 348 and VDE 411 for normally
eff
Indication
RM LED lit
RM LED dark
PE LED lit
PE LED dark
N LED lit
L1 LED lit
OFF LED blinking
OFF LED dark
Subject to change without notice