Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installing the Deck Chute
1.
With the tractor's discharge chute
raised up and held open (1), install
the chute elbow by placing the
chute elbow mounting rod into the
chute mounting tab (2), as shown in
Figure 4-12.
1
Figure 4-12
2.
Secure the chute elbow to the deck
using a wing knob (720-04122)
from hardware pack 689-00567. See
Figure 4-13.
Note: If present, remove the
protective cap off of the mounting
stud on the mowing deck as shown
in the upper inset of Figure 4-13.
1
2
Figure 4-13
Important! Be certain that the bottom of
the discharge chute is located inside of the
lip of the deck opening, as shown in Figure
4-14.
Figure 4-14
2
Installing the Upper Chute Tube
1.
Thread the upper end of the chute
tube securely into the upper chute
support. There are two tabs on
the lower inside part of the upper
chute support to allow for secure
threading. See Figure 4-15.
NOTE: The chute tube and upper
chute support are left-hand
threaded. Thread counterclockwise
until secure.
Figure 4-15
2.
Lift by the handles at the bottom of
the chute tube. Slide the chute tube
over the chute elbow mounted on
the cutting deck, as shown in Figure
4-16.
2
1
Figure 4-16
3.
Make sure the connection is secure
and there are no gaps between the
chute tube and the chute elbow.
4.
If open, close the grass catcher cover
prior to mowing.
S
4 — A
& i
ection
SSembly
nStAllAtion
9
Tabla de contenido
