Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Assembly & Installation
NOTE: References to left, right, front and
rear of the tractor are from the operator's
position, unless otherwise stated.
•
Before assembly, place the tractor on
a firm, level surface, disengage the
PTO, stop the tractor engine and set
the parking brake.
•
For convenience, pivot the seat
forward and leave it in that position
until the grass collector is fully
mounted and assembled.
Remove Bumper Assembly
1.
Remove bumper assembly. See
Figure 4-1.
Figure 4-1
Note: Your tractor's bumper
assembly may appear different than
pictured. Refer to your Operator's
Manual.
WARNING:
DO NOT re-use mounting
hardware from bumper assembly.
Mount Assembly on Tractor
Install mounting assembly on tractor as
follows:
1.
Secure the mounting brackets to the
tractor using six (710-04043) hex
screws and six (712-04063) flange
lock nuts from hardware pack (689-
00567). See Figure 4-2.
Figure 4-2
Note: Tighten all of the hardware on
the mounting assembly at this time.
2.
Install bracket mounting plate (783-
06168) with four bolts (710-0276) and
four nuts (712-04063) from hardware
pack 689-00567 as shown in Figure
4-3.
Figure 4-3
3.
Install the upright support bracket
onto the mounting assembly on
the tractor by hooking it over the
mounting assembly between the two
tabs as indicated in (1) Figure 4-4.
4.
Secure the upright support bracket
to the mounting assembly with a
(710-0376) hex bolt and (712-04063)
flange lock nut from hardware pack
(689-00567). See (2) Figure 4-4.
Figure 4-4
5.
Install the hanger assembly onto
the upright support bracket using
a carriage bolt (710-0276) and wing
knob (720-04122). See Figure 4-5.
Figure 4-5
4
7
Tabla de contenido
