Hkoenig WBT300 Manual De Operación página 4

25. The head of the unit is at high temperature during
operation. Unplug the unit and wait till it's cool before
cleaning.
26. The unit should be plugged in a socket, which is easily
visible and reachable.
Preparation
• Unpack the carton. Take out the accessories pack from the carton of the heater body. Make sure
the accessories listed in the above Accessories Check List are included. If anything missing, ask
the retailer immediately to provide it to you.
• Prepare a cross head screw driver.
• Read this instruction manual carefully before installation and use. Keep this instruction manual
in a proper and safe place for future use in case needed.
Installation:
• Take out all the components form the cartons.
• As shown in figure A, turn over the Base and Base Cover, let Screw M6*12(#7) fix the
Wheels(#5) through the small holes on the Base.
• Fix Screw Feet M6*30(#1) onto the Screw Board(#16), and adjust it into the same level as the
Wheels.
• Put Spring Washer ø8.5(#23) and Spring Washer ø8.2*ø16(#24) into the Screw M8*120(#4)
then get through the Base(#6), Base Cover(#9), S/S Tube(#10). Use the provided Allen Key M8
to fasten the Screw M8*120（#4）with Foot Bracket.
• Turn over the Heater Body. Put the Base on it. Pull out the Power Cord（#14） through the Base
Cover（#9） and Base（#6）.
• Let the Base Brackets（#8） match with the holes on the Base Cover(#9)and Base(#6). Then
fix the Base Brackets with the Washers(#3) and Screw M6*20 (#2) with the provided Allen Key
M6.
• Fix the Power Cord with the Cord Clip(#15).
• Put Table Top on top of the Heater Body. Make sure the screw holes on Table Fixture are
matching the holes on Top Steel Board. Fix Table Top onto Heater Body with 4 Screws M6*8
(#20) and Spring Washers ø6.2(#11)
Operations:
• Plug in the unit to a socket. Make sure the power supply is same as rated.
• Press Switch(#30) to switch on the power. Heater is shifted to Standby mode. Power Indicator
Light starts flashing.
• Press "MODE" button on the control panel or on the remote controller to switch on or to shift it
to different power of the heater, Low (Green Light), High (Red light).
• Press "OFF" button to shift the heater to standby mode. The indicator light starts flashing again.
• Press Switch(#30) again to cut off the power totally in case the heater is not to be used for a long
time.
WARNING:
This heater is not equipped with a device to control the room temperature. Do not use this heater in
small rooms when they are occupied by persons not capable of leaving the room on their own,
unless constant supervision is provided.