Tabla de contenido
Idiomas disponibles
Idiomas disponibles
I N S T A L L A T I O N
5
Installation
E N
5.1
Milling machine
Countries with 100-115 V mains voltage
The machine is preset for a mains voltage of
230 V. When the mains voltage at the set-up loca-
tion is 100-115 V:
▷ Pull out the fuse compartment ([9] in fig. 2 on
page 27) below the mains plug.
▷ Replace both T3.15 A fuses with the provided
T6.3 A fuses.
5.1.1
Set-up of the milling machine without
supply unit
Please refer to the separate milling
machine set-up instructions.
_ The machine is intended exclusively for use
within dry, closed rooms.
_ A clearance of at least 200 mm is to be
observed sidewards, to the rear and upwards.
Minimum space requirements for the milling
machine (incl. connections):
▪ Width: 810 mm
▪ Depth: 630 mm
▪ Height: 740 mm
_ The empty weight of the machine is 45 kg. The
set-up surface must withstand an appropriate
load.
_ During operation, the room temperature must
be between 18 °C and 30 °C; avoid large varia-
tions in temperature.
▷ Set up the machine on a sturdy work table or
work bench (off the ground and clear of walls).
▷ Adjust the height of the machine by screwing
the feet in or out, ensuring that the machine is
positioned firmly on all four feet.
28
▷ Insert the extraction hose of the extraction sys-
tem being used to the extraction-hose connec-
tion ([10] in fig. 2 on page 27) on the rear side of
the milling machine.
▷ Connect the compressed-air hose on the rear
side of the milling machine.
5.2
Maintenance unit
The spindle is equipped with a sealing-air feature.
This sealing air prevents shavings/chips and dust
from entering the spindle. The service unit filters
possible contamination in the sealing air and thus
prevents costly machine damage.
Installing the service unit
1
3
P=6 -8b ar
Fig. 3
Maintenance unit
1 Knurled screws
2 Compressed-air hose, 250 mm
3 Compressed-air inlet
4 Water separator
5 Compressed-air connection, milling spindle
2
4
5
Capítulos
Tabla de contenido
