Master Lock NightWatch DEADBOLTS Guia Del Usuario página 10

To reactivate the stored codes...
Press the "Program" button until the keypad on the exterior of the
door begins to flash blue. When it flashes blue you can release the
button.
Enter your personal administrative code...
9-0
Push the button, the function activating all stored codes,
and press .
Enter
If the keypad lights in green the reactivation has been confirmed.
If it lights red the codes weren't reactivated and you'll need to
repeat the steps again.
Reset Factory-Set Administrative Code
You can easily reset the administrative code to the factory setting. If
you do this ALL user codes will be cleared.
Press the "Program" button until the keypad on the exterior of the
door begins to flash blue. When it flashes blue you can release the
button.
Press the "Program" and the "Exit" buttons (under battery holder)
together and hold them until the keypad turns solid blue – about
60 seconds.
At that point all user codes have been removed and the
administrative code has been reset to the factory set code. The
factory administrative code can be found on the label on the inside
front cover (pg. 2) of your User Guide.
10