Magneti Marelli FLEX TESTER Guía Rápida página 74

2. Attenuator 20:1 If connected between the flex and the standard probe it Reduces
the input signal at a good level in presence of signal more than 200V. The Flex SW
with this setting shows the real Value voltage on the screen
3. 20A amperometric clamp. Connect the standard probe to acquire Current value.
Please check that the 9V battery in inserted into the clamp, the selector is in 20A
position,and that the green led is on. The Flex SW with this setting displays the real
Ampere
4. 60A amperometric clamp. Connect to the standard probe to acquire Current
value. Please check that 9V battery in inserted into the clamp, selector is in 60A
position and green led is on. The Flex SW with this setting show the real Ampere
value on the screen
5. 600A amperometric clamp. Turn on standard probe to acquire Current value.
Please check that the 9V battery is inserted into the clamp and that the green led is
on. The Flex SW with this setting displays the real Ampere value on the screen
6. NVH OPTIONAL. Connect the NVH probe to Flex through the appropriate hardware
interface. The Flex SW with this setting displays the real acceleration value on the
screen with FFT calculation.
7. Secondary Ignition (not inverted) OPTIONAL. Connect secondary or coil probe .
The Flex SW with this setting displays the real voltage.
18