If you want to use WMM – Power Save or Direct Link, you must enable WMM. The
setting method of enabling WMM indicates as follows:
•
Click WMM Enable, then click Apply. Change to Site Survey Page. And
add a AP that supports WMM features to a Profile.
•
Click WMM – Power Save Enable. And Click Setting... button. After
clicking Setting... button, show Power Save Setting dialog. Please select
which ACs you want to enable. Then click Apply button. The setting of
enabling WMM – Power Save is successfully.
•
Direct Link Setup Function will be released with the new driver.
3.2.7 About
The About section shows the Driver Version, Firmware Version, MAC Address, IP
Configuration and the Utility version.
ENGLISH
52