Overhead Rigging - JB Systems COB-PLANO Manual De Instrucciones

ENGLISH
 Due to safety reasons it is prohibited to make unauthorized modifications to the unit.
Important: Never look directly into the light source! Don't use the effect in the presence of persons suffering
from epilepsy.
DESCRIPTION:
1. FILTER FRAME: if in some cases, you need a beam that is much wider to lighten up a large surface,
you can take off the frame with the narrow beam lens. Just unscrew the 2 knobs (1a) to do this.
2. IR RECEIVER: for the wireless remote control.
3. DOUBLE BRACKET: with 2 knobs to fasten the unit in the desired position and a mounting hole to fix a
truss clamp.
4. DMX INPUT: 3pin male XLR-connector used to connect the projector with the DMX controller or with the
previous unit in the DMX chain.
5. DMX OUTPUT: 3pin female XLR-connector used to connect the projector with the next unit in the DMX
chain.
6. DISPLAY shows the various menus and the selected functions.
7. MENU button: used to browse the different functions in the menu
8. ENTER button: used to confirm your choice or to enter the setup mode of a function.
9. UP button: to increase the values shown on the display.
10. DOWN button: to lower the values shown on the display.
11. Mains input: with IEC socket and integrated fuse holder, connect the supplied mains cable here..
12. Mains output with IEC socket: you can use a special IEC power cable to connect this output with the
mains input of the next COB PLANO for easier linking up to 10A.

OVERHEAD RIGGING

 Important: The installation must be carried out by qualified service personal only. Improper
installation can result in serious injuries and/or damage to property. Overhead rigging requires
extensive experience! Working load limits should be respected, certified installation materials
should be used, the installed device should be inspected regularly for safety.
 Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging
and servicing.
 The device should be installed out of reach of people and outside areas where persons may walk by or be
seated.
 Before rigging make sure that the installation area can hold a minimum point load of 10times the device's
weight.
 Always use a certified safety cable that can hold 12times the weight of the device when installing the unit.
This secondary safety attachment should be installed in a way that no part of the installation can drop
more than 20cm if the main attachment fails.
 The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!
 Don't cover any ventilation openings as this may result in overheating.
 The operator has to make sure that the safety-relating and machine-technical installations are approved by
JB SYSTEMS
®
3/51
USER MANUAL
COB PLANO