Craftsman 536.882650 Manual Del Usuario página 20

• Replace the belt cover.
• Check the clutch control cable
adjustment
• Reconnect the spark plug wire
TRACTION DRIVE BELT
The traction drive belt (see figure below)
has constant spring pressure and does not
require adjustment,
• Replace the traction drive belt if it is slip-
ping (see To Replace Belts paragraph on
this page),
TO REPLACE BELTS
The drive belts on this snow thrower are of
special construction and should be replaced
with original equipment belts available from
your nearest SEARS Store or Service Cen-
ter.. You will need the assistance of a second
person while replacing the belts,
Drain the gasoline from the fue! tank by re-
moving the fuel line at the carburetor,. Drain
the gas into a container and reinstall the
rue! line,
/_. CAUTION: Drain the gasoline out-
doors, away from the fire or flame,
AUGER DRIVE BELT
If your snow thrower will not discharge
snow, and the auger drive belt (see figure
below for location) is damaged, replace it
as follows:
Auger Drive Belt
Pulley er Drive
Traction Pulley
Drive Bell
Bett Guide
(Right Hand) (Left Hand)
Auger Idler
Pulley
- Disconnect the spark plug wire
• Remove the belt cover (see next figure ).
Bert
1!4 X t/2 Ihch self4apping Screw
• Loosen the belt guides (see first figure on
this page) and pull away from the auger
drive pulley
. Remove belt from auger drive pulley,
, Remove top two bolls that secure auger
housing to motor mount frame, Loosen
bottom two bolts Auger housing and mo-
tor mount frame will separate, hinged by
bottom two bolts (see second figure on
page 21)
• Remove old belt from the auger drive pul-
ley.,
• Position new belt on auger pulley
, Replace top two bolts, and re4ighten bot-
tom two bolts
• Adjust the belt guides (see To Adjust The
Belt Guides paragraph on page 21),
• Reinstall the belt cover
, Reconnect the spark plug wire,,
TRACTION DRIVE BELT
tt your snow thrower will not move forward,
check the traction drive belt (see first figure
on this page) for wear (Check other causes
also in the Trouble Shooting Points section).
If the traction drive belt needs to be re-
placed, proceed as follows:
- Disconnect the spark plug wire
• Remove the belt cover (see figure above),
• Loosen the belt guides and pull away
from auger drive pulley (see first figure
on this page)
• Remove auger drive belt from auger pul-
ley (see first figure on this page)
• Pull the traction drive bell idler pulley
away from the traction drive belt (see first
figure on this page)
• Remove the traction drive belt
• Position new traction drive belt onto trac-
tion pulley
• Pulf idler pulley away from belt, allowing
belt to be positioned onto auger pulley
20